CHARACTERIZATION AND SELECTION OF MORTAR SAMPLES FOR RADIOCARBON DATING IN THE FRAMEWORK OF THE MODIS2 INTERCOMPARISON: TWO COMPARED PROCEDURES

For several decades, many efforts have been dedicated to enhancing the accuracy of mortar radiocarbon dating and evaluating the reliability of the results concerning the typology of the examined specimens. Several assumptions that are fundamental for the application of the method may be in many cases not fulfilled, such as (a) complete primary limestone dissociation during calcination, (b) efficient separation of geogenic carbon contained in calcareous aggregates, (c) short carbonation time, and (d) absence of secondary calcite. Many laboratories all over the world have proposed different methods to select suitable fractions of mortar. The first intercomparison attempt, involving eight international laboratories, was organized in 2016 aiming at comparing and statistically treating the results obtained on the same materials by different laboratories with their own characterization and pre-treatment methods (Hajdas et al. 2017; Hayen et al. 2017). Following this first step, a new intercomparison experiment was proposed and set up in 2018 during the Mortar Dating International Meeting (Bordeaux, FR). A new set of three mortar samples was chosen, taking care of the selection of standardized materials (homogeneity, known mineralogical composition, absence of exogenous inclusions, known expected age). This work describes the results of two research teams involved in the intercomparison. The samples were characterized, selected, and dated depending on each laboratory strategy. The results stress the importance of the characterization of the raw material is to better understand the mineralogical and petrographical composition of the samples. Such information can support the choice of the most appropriate strategy for the extraction of CO2 and then for data interpretation.